[bb001961]

I've read a few different threads with advise on what wires to use for the killswitch wire but they are all different. I don't want to cut into the wrong wires and mess something up. Does anyone out there have pictures of where to tap into or at least a better description of what wire to use? This quad's wiring is a lot more confusing than my past quads. Thanks for any help.

 

[tlronny]

Depends on what switch you have first ?

 

[bb001961]

I have the Pro Armor switch. One of the wires needs to be grounded and the other connected to a wire between the stator and the coil according to the instructions. I just don't know where that wire it located.

 

[tlronny]

That would be the white wire coming up from the stator on the left hand side near the subframe junction.
It is in a 2 wire connector with a blue wire as well.
The connector is easy to spot as the two wires are quite small compared to the rest of them.
That white wire actually goes up the front too but I dont know what colour it changes to.(someone else may help with this as you can then hook up to it without having to run a wire all the way down the left hand side !).
I think there is a post here about this colour change ?
Hope this helps.

 

[bb001961]

Thanks a lot, I'll try it tonight and let you know if I can find the wire.

 

[MikeLT-R]

Thanks a lot, I'll try it tonight and let you know if I can find the wire.
[/b]

If you haven't found it yet the wire in the front is green with white stripe

 

[tlronny]

Does that go into the ECU at the front then ?