Hiper Mounting

927 Views 6 Replies 4 Participants Last post by madmatt, Sep 27, 2006

ltrkyle489

Discussion Starter · Sep 17, 2006

what all are you guys using to mount these rims? I know to turn the nut around so the beveled side it facing outward, but do any of you use like a flat washer, then locking washer, then just a regular nut? I thought I have hear of people doing that before. I sttripped some aluminum off of my Bajas when they were on my 300, and it made it hell to take those off and put back on, I had to hit them with a rubber mallet sometimes. So I was wanting to know what all I should use, or if just flipping the nuts is good enough.

Save

1 - 1 of 7 Posts

R450_Guy

· #2 · Sep 17, 2006

what all are you guys using to mount these rims? I know to turn the nut around so the beveled side it facing outward, but do any of you use like a flat washer, then locking washer, then just a regular nut? I thought I have hear of people doing that before. I sttripped some aluminum off of my Bajas when they were on my 300, and it made it hell to take those off and put back on, I had to hit them with a rubber mallet sometimes. So I was wanting to know what all I should use, or if just flipping the nuts is good enough.
[/b]

You are going to have to go and find yourself some regular nuts, if you turn them around you cant get a socket on them and cause of the point on the other side it will wrech everything! For what its worth just get some proper nuts!!

Save

1 - 1 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month