[LTR450_#67]

Guys I am stumped. I put a 13 tooth front sprocket on and the chain was pretty loose after I adjusted it. So I took out 1 link and now I can't even connect the chain unless its singin tight and that's with it adjusted all the way loose. So does that mean I should get a half link? What do you guys think? Did I not catch something while trying to connect the chain? I'm going to go double check it!

Thanks
Aaron

 

[AL Elks]

That sucks. You should not have had to cut the chain. I had tons of adjustment to get mine tight when I put the 13 tooth on. About the only thing you can do now is put another link in using a 2nd master link . I had to do that to my LTZ because I cut it 1 link too short. It works fine.

 

[MXQuadRacer]

That chain adjuster goes a LONG way...if it absolutely would not adjust to where the chain would not have worked, and you cut a link it will work no question. There is enough adjustment overlap to where it has to work in one scenario or the other

 

[kidsdad0101]

Over 6 inches of chain tension adjustment. Back it out to "full in". Put chain on loosely and tighten as needed.

 

[LTR450_#67]

Thanks for the input guys. I appreciate it! My bad... I should have double checked it.

Thanks again
later
Aaron