Front brakes stopped working, need advice

2065 Views 6 Replies 6 Participants Last post by JoeyLTR, Apr 18, 2012

JoeyLTR

Discussion Starter · Apr 16, 2012

Was trail riding yesterday and halfway threw I pulled the front brake lever and it pulled right to the grip with no resistance. The fluid level indicator above the brake lever shows full still but they do not work. Any advice on where to start and what to look for would be greatly appreciated.

Save

1 - 1 of 7 Posts

250slurpee

· #5 · Apr 16, 2012

i bent the brake caliper mount and it caused that

Bump Start Racing!!!!!!:rockwoot:
my money pits!!!!!
-2009 ltr 450 ltd red pro armor kilswitch, protaper atv lows, houser +2 houser stem, houser sli-cast fox evolx/podiumx, crbm, yoshi full system, houser pro bounce nerfs, pro armor bumpers, billet case saver gas cap and p brake block off , hinson billet clutch hub, clutch plates and springs, hiper tech 3's maxxis razr cross fronts and razr xm rears
-07 ltr 450 yellow:rock: 493 weisco big bore, pcv with auto tune, hinson clutch plates and springs,yoshi slip on, yoshi kickstart, pro armor fat pegs, pro race grab bar, dominator bumper, pro taper atv lows, blue beak, renthal o-ring chain, moose sprockets and discs, tag railer, fuel shift pin, razr mx rear, itp quadcross fronts, pro armor kill switch blingstar sprocket and disc gaurds, hotcams, currently dropped a valve and missing the pipe.
more mods to come!!!!

2003 f350 sc sb lariat 7.3 diesel
2005 m7 decked
2005 arcticcat 400 4x4 2'' lift 26'' itp xtr radials

Save

1 - 1 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month