Fi Light On!!

3120 Views 7 Replies 3 Participants Last post by quadmonkey, Sep 8, 2007

R450MX

Discussion Starter · Aug 17, 2006

Ok guys just got done installing Nmotion, Dyna FI Programmer and Pro Design intake. After it starts up and idels for a minute or so the FI light is coming on. It runs fine, actually better than ever. It does seem to be running a little hot. It's not blinking its staying lit solid. And if I shut it off it starts right back up again. Is this anything I should be worried about? Im leaving for Englishtown in the morning so I guess I will just have to fiddle with it there.

Save

1 - 4 of 8 Posts

R450MX

Discussion Starter · #3 · Aug 17, 2006

Actually I might have mixed up my lights. How low does the fuel need to be to trigger that light? My fuel is pretty low.

Save

R450MX

Discussion Starter · #5 · Aug 17, 2006

Ok good I think that's my problem...Well Im really hoping thats what I did. I am getting gas in the AM, unfortunatly I have none right now to try.

Save

R450MX

Discussion Starter · #7 · Aug 17, 2006

Well I checked everything and my lights ARE in the right places.

I turn my key on, dont start it, and after about 30 seconds it comes on.... It ran great all night so im just going to run it.....

Save

1 - 4 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month