Suzuki LT-R450 Forum :: banner
1-16 of 16 Results
  1. General Discussion
    Ok, so I have a 2007 LTR 450 that I got rebuilt because I thought that I blew first gear. My mechanic tore down the whole motor and sent me a picture of my clutch. It was destroyed and he said all the gears were fine. I was confused because before we took the motor out, I was still able to ride...
  2. Wanted
    Hey guys looking for a used hinson clutch cover. Let me know what you have, also pm me and I can give you my email to send pics to. Paypal ready! Thanks
  3. Engine/EFI/Drivetrain
    '06 LTR450, I've had the bike since new. Not a single issue with it other than teaching too many people how to ride on it. My buddy today burnt out the clutch, yesterday I noticed the clutch not grabbing until the lever was basically all the way out. Made an adjustment and it operated fine...
  4. Engine/EFI/Drivetrain
    There is a thread on this already... but there is no follow up to confirm if it worked. my starter is spinning freely (wont engage, or even turn the crank) when trying to start and I read that the starter clutch one way bearing being backwards could cause this. just trying to see if anyone has...
  5. Engine/EFI/Drivetrain
    I have 2006 or 2007 LTR that I just bought off my friend. I took it riding a few times. The other day I went to ride it again and I put it in first gear. When i released the clutch i hear a loud grinding noise. I haven't tried to drive with it in first gear because I don't want anything else to...
  6. For Sale
    everything here is $30 shippped OBO EACH EMAIL ME DIRECT IF YOU WANT A RAPID RESPONSE [email protected]
  7. Body/Controls/Protection
    I was thinking of getting one? Opinions? Pros and cons? I race Cross-Country if it makes a difference. thanks guys
  8. Engine/EFI/Drivetrain
    My 08 ltr clutch just started slipping right after i changed oil. i put Motul 10w-40 in it. my local dealer said its a very good oil for the suzuki's. well right after i changed the oil took it for a ride and just a little bit of throttle its fine but when i get on it it slips. i tore apart the...
  9. Engine/EFI/Drivetrain
    I have a minor problem i don't know how to fix... here it goes when i have been park and in neutral my shifter won't move down into firt...i have to wiggle it and it will eventually rarely does it when riding and the engine/clutch sounds perfect! what could it be? thanks:shocked:
  10. Engine/EFI/Drivetrain
    A little help needed. I put in a BCS bracket due to the shift pin boss braking (engine case). When I put the bracket in I lose shift motion up or down and will not shift through the gears. If I take the bracket out and move the gearshift lever I have full motion. I have the gearshift shaft...
  11. For Sale
    Sold sold
  12. Body/Controls/Protection
    Hey everyone, I'm new to the site and just bought a 06 LTR and I have a question. I just got it last week and I was wondering how the clutch should feel when you take off. Mine feels totally different then anything I've rode before, which was mainly motorcycles. If I let it out real slow I can...
  13. Suspension / Steering / Chassis
    clutch cable has to much play I had to change my clutch cable i used the streamline steel braided one. I install it tested it every thing was good until i went for a ride, then the cable just seemed as tho it was getting longer so the clutch was not engaging when i pulled it. I adjusted the...
  14. Engine/EFI/Drivetrain
    hey there. i got a 2006 ltr 450 that will start and idle and rev up great when the bike is in neutral. i can pull in the clutch and it still works great, but once i put it in gear it dies. i thought the clutch might not be disengaging but its not that because i can get the revs up before i put...
  15. Engine/EFI/Drivetrain
    Clutch Install Help I'm putting new clutch plates in my LTR450 but have a questions. When installing the fiber plates where do the tabs on these plates go? The clutch basket has fork like things that stick out, do the tabs go inbetween the different forks or do the tabs go in the fork inserts...
  16. Engine/EFI/Drivetrain
    My buddy has an 07 LTR w about 10 hours on it before it started making horible lower end noise...after removing side case we found the crankshaft balancer driven gear(drives the clutch basket)was loose, and by loose I mean only the side case was holding it on at that point. I torqued and...
1-16 of 16 Results