Feedback Score: 12 reviews
Join Date: Nov 2006
Location: Charleston WV
I really wasn't going to tie a knot in the cable but I did think about it since there was so much pissin cable left over after I adjusted both locations all the way out. I'll try an LTZ cable and look for a CRF450 clutch lever on ebay.
I run the +2 motion pro throttle cable for a TRX450R and it's almost to short with my +2 stem but it's working - - Long live the Carb!
The CRF lever will allow you to run the hotstart on your CRF carb. I think the cable needs to be +8 or +10. It should work on a carb as that's the cable I use on my efi quads
Factory motion pro cables are already +2 but it you need a longer one motion pro will make you one for a 5 dollar custom fee.
Sunline makes a factory CRF replacement with the hotstart lever. Cernics used to sell it.
My MX quad I run the Magura hydro with the hot start top cap with the custom motion pro hot start cable. Looks and works factory. Also has a full Hinson with BTL slipper installed.
My XC quad I run the LTZ400 cable with the work connection billet elite perch with hot start and the same custom motion pro cable. Again looks and works like a factory. This quad also has a rekluse in it
Doug Bird #287
06 LTR450 - FOX/Houser/Williams -MX
09 LTR450 - FOX/Houser/ATP - XC
Thank you everyone for 2012 - GT THUNDER, BNR Motorsports, Motoworks, DWT Wheel, Fast Traxx Crew, X County Photos, Houser Racing, Rekluse, Fasst Co, Maxxis, MMX Graphics, Mr. Hole-shots and Casto Motorcycle sales.